Home Dynamix HP-51M - Manual (Page 41)

DYNAMIX HP-51M Coax MDU Master Bridge User’s Guide
35
Note that Telnet connection will be terminated automatically if the telnet client doesn’t input any command for 5
minutes; i.e. the console idle timer is 10 minutes (600 Sec).
Command Sets for Telnet Console
The following table lists all commands for Telnet console. The third column ‘ Description ’ explains what happen
when you run the ‘ Commands ’ in the first column and also explains the versatile options of the second column
‘ Arguments ’.
Some common formats for arguments are:
<mac> MAC address, format in ‘ nn - nn - nn - nn - nn - nn where nn =00~FF’. As ‘00-01-40-13-03-36’.
<ip> IPv4 address, format in ‘ nnn.nnn.nnn.nnn where n =0~9’. As ‘192.168.1.1’. Also applicable for
<mask> , <default gateway>
<interface> Network interface name, ‘ eth0 ’ for LAN1/LAN2 interface, ‘ hpna0 ’ for HCNA interface.
<fid> Flash ROM file id represented different firmware/driver, ‘ n where n =0~12’,
‘ n =0’: System bootcode (bootloader)
‘ n =1’: System firmware (OS)
‘ n =2’: Master HCNA driver (3110)
‘ n =3’: 3010 EP HCNA driver
‘ n =5’: 3110 EP HCNA driver
‘ n =10’: 3010 EP diagnosis utility
‘ n =11’: 3110 EP diagnosis utility
Only lowercase letter can be accepted. Typing commands followed by pressing ‘ENTER’ will execute the command.
Run any command with ‘-h’ argument will show you the usage
Commands
Arguments
[ ] is optional
Description
dconfig
Dump all configurations/settings.
default Reset all settings to factory default, except Password.
diag
-t <mac>
-r <mac>
On-line EP connection diagnosis.
-t: downstream SNR diagnosis(from Master to EP)
-r: upstream SNR diagnosis(from EP to Master)
<mac> : EP MAC <mac> to be diagnosed