Home Dynamix HP-51M - Manual (Page 19)

DYNAMIX HP-51M Coax MDU Master Bridge User’s Guide
13
Yellow: For Master, it has inconsistent ‘Privacy Mode/Key’ settings. You may upgrade the Master’s driver to
synchronize its working values. (to replace the running working values with the setting ones).
Red: For banned EP, either ‘Privacy Mode/Key’ in EP is not matched or the ‘Host Limit’ value in EP is 0. HP-
51M will refuse to serve this EP.
EP HomePNA Properties (HPNA)
EP (either Smart or not) conforms to the following HomePNA settings stored in HP-51M Master,
Note
Footnote to the EP (user).
Host Limit
Specify the maximum allowable host (as PC) number attached on this EP:
0: Service is disabled, none host is allowed
1~255: The factory default value is 255 for unrestricted.
Upstream Rate
Limit the maximum allowable upstream bandwidth (value multiplied by 64Kbps) of one EP. It is a HomePNA
upstream traffic throttle enforced by EP built-in HCNA driver (Regard as Software bandwidth control, works for
HCNA port in the upstream direction).
0: unlimited
1~1563: *64Kbps for the maximum upstream rate.
Master/Smart EP Ethernet Properties (Ether)
The Ethernet properties of Master device and Smart EP device are configurable. For those EPs equipped with he
fixed Ethernet properties are remarked as un-configurable EPs – usually based on 3010 chipset.
Port Setup
To configure built-in Ethernet switch port properties, include speed, flow control, and maximum In/Out rate
(bandwidth control) of port LAN1/LAN2/HCNA.