Home Dynamix HP-51M - Manual (Page 7)

DYNAMIX HP-51M Coax MDU Master Bridge User’s Guide
1
1
II
NTRODUCTION NTRODUCTION
This chapter describes the features of your HomePNA3.1 over Coax to Ethernet Master (Management) Bridge --
HP-51M. Refer to “HomePNA3.1 over Coax” as HCNA from this point.
Features
♦ One HCNA Port for Driving HomePNA3.1 Signal into Existing Coaxial Cable
♦ One TV/Antenna Port for TV Set Connection or for TV Signal from VHF/UHF Antenna/CATV
♦ Two Fast Ethernet Port with Auto-Detect MDIX Function(Auto Crossover) and Auto-Negotiating Half/Full
Duplex 10M/100M for Expansion or Link to FTTx/xDSL Modem
♦ One Reset Button
♦ Priority Queue based QoS Support for 802.1p, IP TOS, UDP/TCP Protocols
♦ Supports up to 31 EP (Endpoint, as HP-51S Slave Unit) Concurrent Connections
♦ Built-in Diagnostic Function for Individual EP Connection
♦ Built-in Web Server and Telnet Server to Support Remote Configuration via Web Browser or Telnet Protocol
♦ Supports Remote HTTP/TFTP Upgrade Function for System Firmware and HCNA Driver
♦ Supports HCNA Driver Upgrade On-line for Connected EPs
♦ Supports SNMP Function
Glossary
♦ HCNA HomePNA3.1 over coaxial cable
♦ MDU Multiple Dwelling Unit
♦ Coax Coaxial cable
♦ SyncMode HCNA device operates in Synchronous mode
♦ AsyncMode HCNA device operates in Asynchronous mode
♦ Master
Master HCNA device in one coax network
♦ Slave Slave HCNA device in one coax network
♦ EP Endpoint, equivalent to Slave HCNA device, as HP-51S
♦ Smart EP Smart Endpoint, as HP-51S. HP-51M could configure Smart EP’s Ethernet properties.
♦ QoS
Quality of Service
♦ M/C Fiber-Optic Ethernet Media Converter
♦ Mixer Coax device sums two or more signals into one
♦ Splitter Coax device divides a signal into two or more smaller and approximately equal signals.
♦ Combiner Coax device adds several discrete signal inputs to one and has high isolation between inputs
♦ Duplexer Coax device separates 2 signals within the same band
♦ Diplexer Coax device separates 2 signals in different bands
♦ Tap Coax device uses for matching impedance or connecting subscriber drops
♦ dB Decibel, to express either a gain or loss power ration(log) after the signal has been transmitted