Heat & Glo Fireplace Heat & Glo PALOMA-BZ-MOD - Manual (Page 34)

Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12 34
G. Installing the Vent Restrictor
The vent restrictor plate must be installed before installing
the baffle.
On the top of inside firebox for top vent ,on back of firebox
for rear vent, loosen the three screws out about 1/8 in.
Place the vent restrictor plate over the the screws and
slide into locking position. Retighten the screws. (See
Figure 8.15.)
For vertical venting above 15 ft. a vent restrictor is
required.
Figure 8.15
F. Shutter Adjustment
The shutter is located on the underside of the burner, on
the burner neck (see Figure 8.13).
Figure 8.13
Air Shutter Settings
PALOMA-BZ-MOD
PALOMA-GR-MOD
PALOMA-GY MOD
NG LP
Rear Vent 1/2 in. 1/2 in.
Top Vent 3/8 in. 1/2 in.
9. Install the cover plate and gasket removed from the
rear of the appliance to the top of the appliance with
the screws previously removed. (Figure 8.12).
10. Install the new solid top.
Figure 8.12
Top Vent Top Vent
Rear Vent Rear Vent