Heat & Glo Fireplace Heat & Glo PALOMA-BZ-MOD - Manual (Page 36)

Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12 36
4. Ember material is shipped with this kit. To place the
ember material:
WARNING! Risk of Explosion! Follow ember placement
instructions. DO NOT place embers directly over burner
ports. Replace ember material annually. Improperly placed
embers interfere with proper burner operation.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• Place dime-size pieces of embers in the areas highlighted
in Figure 7. Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.
Figure 7. Ember Placement
REAR ROCK
CLUSTER
RIGHT ROCK
CLUSTER
RIGHT AND REAR CLUSTERS
MAKE CONTACT
Figure 4. Right and Rear Rock Clusters Make Contact
EMBERS
3. Place left rock cluster in fi rebox as shown in Figure 5.
The left end of the cluster should touch the left wall of
the fi rebox. Push cluster back until the rear and left
rock clusters contact each other as shown in Figure 6.
Ensure the rock clusters are not covering any burner
ports.
WARNING! Risk of Explosion! Follow instructions for
placing rock clusters. DO NOT allow rock cluster to cover
burner ports. Improperly placed rock cluster will interfere
with proper burner operation.
BASEPAN LEDGE
Figure 5. Placing Left Rock Cluster
Figure 6. Left and Rear Rock Clusters Make Contact
REAR ROCK
CLUSTER
LEFT ROCK
CLUSTER
LEFT AND REAR
CLUSTERS MAKE
CONTACT
LEFT ROCK
CLUSTER