Heat & Glo Fireplace Heat & Glo PALOMA-BZ-MOD - Manual (Page 35)

35 Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12
H. Installing Rock Media and Ember Material
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.
KIT CONTENTS
(1) Rear Rock Cluster
(1) Left Rock Cluster
(1) Right Rock Cluster
(1 ) Bag Ember Material
INSTALLATION
1. Place the rear rock cluster in the fi rebox as shown in
Figure 2. The fl at portion should fi t tight against the
back of the fi rebox. Slide cluster to the right. There are
notches on the bottom of the rock cluster that should fi t
over the base pan. Cluster should rest on burner and
base pan.
2. Place right rock cluster in fi rebox as shown in Figure
3. The right end of the cluster should touch the right
wall of the fi rebox. Push cluster back until the rear and
right rock clusters touch as shown in Figure 4. Ensure
the rock clusters are not covering any burner ports.
REAR ROCK
CLUSTER
NOTCHES ON
REAR ROCK
CLUSTER
LEFT ROCK
CLUSTER
RIGHT ROCK
CLUSTER
Figure 2. Placing Rear Rock Cluster
Figure 1. Rock Kit Components
Figure 3. Placing Right Rock Cluster
RIGHT ROCK
CLUSTER
NOTCHES ON
REAR ROCK
CLUSTER
WARNING
Delayed Ignition Risk
• Place rock clusters according to instructions.
• Do NOT place rock clusters in a position that
they cover burner ports.
• Do NOT use any media other than the rock
clusters supplied with this fi replace.
Fireplace will not function properly.
Delayed ignition may occur.