Heat & Glo Fireplace Heat & Glo PALOMA-BZ-MOD - Manual (Page 42)

Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12 42
L. Inner Glass Door Assembly Replacement
Turn the appliance OFF and let it cool down before replac-
ing the inner glass door assembly.
With the front door assembly removed from the appliance,
remove the inner glass door assembly by disengaging the
spring-loaded latches at the bottom of the appliance and
lifting off of the two spring-loaded latches at the top of the
appliance.
Replace with a new inner glass door assembly.
K. Front Door Glass Assembly Replacement
Remove the front door assembly by pulling bottom of front
away from appliance and lifting it off of the spring-loaded
latches on top of the appliance. See Figure 8.32.
Figure 8.34 Complete Assembly
CAP AND BARREL FASTENER SYSTEM
Nylon washer on back
and front of glass
Screw
Finishing Cap
Protective barrel sleeve
through hole in the glass
Back side of
front door
Figure 8.32
Position the four fl at 1/4 in. (6 mm) spacer washers on the
front door so that the four mounting screws pass through
them. Position the glass over the front door.
Install the four protective barrels into the glass and the
four nylon washers on top of the glass.
From inside the door front, pass the screws through to the
outside and thread on the caps until tight. See Figure 8.33.
Figure 8.33
WARNING! Risk of Asphyxiation! Handle glass door
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace glass door as a complete assembly.