HP 1Gb/2Gb switch 16B A7340-96002 User Manual
Page 13
Advertising
Installing the Switch
7
– For a Compaq/Rittal rack, assemble each of the two brackets with (2)
spacers, (2) M5 flat washers, and (1) M5 Torx head screw with
captive lock washers as shown in
.
Note
For the Compaq/Rittal rack, the alignment pins will be resting on
the top surfaces of the spacers.
Figure 3. Installing the Rear Rail-Tray Brackets (Compaq/Rittal Rack)
4. Install the Tinnerman clips or nuts by completing one of the following
steps:
– For an HP rack, install (2) M5 U-type Tinnerman clips for each of
the front columns of the rack in the top and bottom positions of the
three-hole EIA pattern as shown in
Advertising