HP 1Gb/2Gb switch 16B A7340-96002 - Manual (Page 9)

Installing the Switch 3
• Four rubber mounting feet (used only for setting up the switch as a
stand-alone unit)
• Two rails and one bag of rail mounting hardware (required if the switch
is to be installed in a rack):
• hp surestore FC 1Gb/2Gb Switch 16B Quick Start Guide
• HP Surestore FC 1Gb/2Gb Switch 16B Documentation CD-ROM
Installing the Switch as a Stand-Alone Unit
This section provides instructions for setting up the switch as a stand-alone
unit on a flat surface. The following items are required:
• FC 16B switch
• Power cables
• Rubber mounting feet
To set up the switch as a stand-alone unit:
1. Check contents of the shipping carton to verify all the required parts and
hardware are available.
2. Apply the rubber feet by completing the following steps:
CAUTION Installing the rubber feet on the switch is recommended to help
prevent the switch from accidentally sliding off the supporting surface.
a. Clean the four depressions that are at each corner of the bottom of the
switch to ensure they are free of dust.
b. Place a rubber foot in each depression, with the adhesive side against
the chassis, and press into place.
3. Place the switch on a flat, sturdy surface.
4. Provide power to the switch by completing the following steps:
a. Connect the power cable to the FC 16B power supply and to a power
outlet. Ensure the power cable is routed so that it is not exposed to
stress.