HP 1Gb/2Gb switch 16B A7340-96002 - Manual (Page 25)

Setup 19
– In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
f. From the terminal emulator application, log on to the switch with
administrative privileges through the serial connection. The default
administrative logon is
admin and the default password is password .
CAUTION Do not change the default password unless local
administration policy requires it.
g. Enter the following at the prompt: ipAddrSet
h. Enter the following information at the corresponding prompts, listed
below:
– Ethernet IP Address [10.77.77.77]: Enter the new Ethernet
IP address.
– Ethernet Subnetmask [0.0.0.0]: Enter the new Ethernet
subnetmask.
– Fibre Channel IP Address [none] : Enter the new Fibre
Channel IP address if desired.
– Fibre Channel Subnetmask [none] : Enter the new Fibre
Channel subnet mask if desired.
– Gateway Address [172.17.1.1]: Enter the new gateway
address.
– Set IP address now? [y = set now, n = next
reboot] : Enter “y” to set now.
i. You can verify the address was correctly set by entering the following:
ipAddrShow
j. Record the IP address on the label provided for this purpose on the FC
16B.
k. Once the IP address is verified as correct, remove the serial cable and
replace the shipping plug in the serial port.