Fluke 434 - Manual (Page 98)

Fluke 433/434
Users Manual
19-4
the up/down arrow keys and ENTER. Then adjust the baudrate with the left/right arrow
keys and leave the menu with F5 - BACK. Baudrate and COM port number in FlukeView
must be adjusted correctly.
F1
F2
F3
F4
F5
Figure 19-2. Analyzer and laptop PC
For correct communication with a printer it is necessary that baudrate and printer type of
Analyzer match with the hard copy device. The Analyzer baudrate and printer type are
adjustable as follows: press the SETUP key, then Function key F4 – USER PREFerence,
and then select Printer using the up/down arrow keys and ENTER. Then adjust the
baudrate with the left/right arrow keys, adjust the printer type with the up/down arrow
keys and confirm with ENTER. Leave the menu with F5 - BACK.
The figure below shows a typical setup with printer DPU-414 and printer adapter cable
PAC91. This setup requires an Analyzer baudrate of 9600 baud.
Figure 19-3. Analyzer, printer DPU-414, and printer adapter cable PAC91
Note
The Analyzer is adjustable to different baudrates for PC and printer.