Farallon Communications 612 User Manual
Page 37
Installing the Netopia ISDN Modem
3-5
Caution!
Do not connect the ISDN cable to the Netopia ISDN Modem’s
RJ-11 analog device por ts (identified by the telephone icon).
These por ts are designed for connecting standard analog
telephone equipment.
5.
Connect the other end of the cable to the RJ-11 or RJ-45 ISDN
wall jack. An RJ-45 jack will accept your cable’s RJ-11
connector.
Caution!
Do not connect the ISDN cable to a standard analog telephone
jack or to an external ISDN network termination device (NT1).
Make sure it is connected to an ISDN jack (also called an ISDN
“U” inter face).
6.
Connect the Netopia ISDN Modem power cable to the
connector labeled 9VDC on the back panel of the ISDN modem.
7.
Plug the transformer end of the power cable into a standard AC
wall outlet.
The LEDs on the front panel (see the front panel figure on
) flash momentarily as the ISDN modem undergoes a
power-up self-test.
8.
Turn on the computer’s power switch and restar t.
9.
To configure the Netopia ISDN Modem,