Farallon Communications 612 - Manual (Page 71)

Configuration using a Macintosh computer 5-7
Note: You can use the ISDN Setup utility for both the Netopia ISDN
Modem Model 411 and 412. The two models suppor t slightly
different features. The software automatically detects which model
you are using and only displays features that apply to that model.
The sections below note the features that are available to only one
of the two models.
If you filled out the ISDN parameters worksheet in Chapter 2 , refer
to it now.
Note: If you ran the ISDN Assistant software, the Switch Type, DN,
and SPID will automatically be entered. The instructions below
describe how to manually fill out all the fields in the Easy Setup
Window.
To configure the Easy Setup window:
1. Choose a switch type from the Switch Type pop-up menu.
2. In the B1 Channel SPID entr y field, enter the SPID associated
with the primar y director y number (DN). If the cursor is not in
the B1 Channel SPID entr y field, double-click in the field or
press the Tab key until the field is selected.
3. In the B1 Channel DN entr y field, enter the primar y DN.
4. Check the box beside the phone por t(s) to which you want to
route calls from telephone number 1. This option lets you route
calls to analog devices connected to the analog device por ts.
For information about call routing,
see the “Call routing to the
analog device por ts” section on page 6-13. (This option is only
available for the Netopia ISDN Modem Model 412.) If you do
not have a secondar y SPID and DN, skip steps
5 through 7 .
5. In the B2 Channel SPID entr y field, enter the SPID associated
with the secondar y director y number (DN).
6. In the B2 Channel DN entr y field, enter the secondar y DN.
7. Check the box beside the phone por t(s) to which you want to
route calls from telephone number 2. (This option is only avail-
able for the Netopia ISDN Modem Model 412.)