Farallon Communications 612 User Manual
Page 45
Configuration using a PC
4-7
The right side of the dialog box shows the ISDN modem’s firmware
version, along with any installed options, such as Multilink PPP. For
information about Multilink PPP,
Disabled items (items that are dimmed) are not applicable and do
not need to be configured.
A status area below the Help, Tools, Update, and Exit buttons
provides the following ISDN status information:
■
Layer 1 status
■
Ser vice Profile Identifier (SPID) for telephone numbers 1 and 2
■
Terminal Endpoint Identifiers (TEI) 1 and 2 (for information
purposes only)
Check to make sure the switch type and SPID(s) the software
configures match the settings the telephone company gave you.
Configuring call routing
The call routing option (the Phone Por t and Phone Por t 2 check
boxes in the Number 1 and Number 2 areas) lets you route calls to
analog devices connected to the analog device por ts. If you have
more than one telephone number, you can route calls from either
number to Phone Por t 1 or Phone Por t 2. By default, all the Phone
Por t boxes are checked. This allows calls to both ISDN telephone
numbers to simultaneously ring devices attached to both por ts. For
more information,
see the “Call routing to the analog device por ts”
The configuration dialog box lets you configure call routing for Phone
Number 1 and Phone Number 2.
10. Check the box beside the phone por t(s) to which you want to
route calls from telephone number 1 and telephone number 2.
B channel data rate
You can configure the B channel data rate for 56 or 64 Kbps. The
data rate you select should match your telephone company’s
B channel rate (for information,
see the “ISDN Worksheet” section
) By default, the B channel data rate on the Netopia
ISDN Modem is set at 56 Kbps. If this setting doesn’t match your
telephone company’s rate, you need to change the setting.