Farallon Communications 612 - Manual (Page 72)

5-8 Netopia ISDN Modem User’s Guide
Note: If you want to change the settings displayed in the
window to the settings currently defined in the Netopia ISDN
modem, click the Rever t button. This button is useful if you
make a mistake entering new settings in the window and want
to rever t to the old settings.
8. Check the Enable Auto Answer box to turn on the auto answer
feature. When Enable Auto Answer is active, the ISDN modem
automatically answers incoming data calls. You might want to
use this feature if you have callback set up in your communica-
tions software or you want to receive incoming data calls over
your Netopia ISDN Modem.
9. Click the Set Modem button to configure the Netopia ISDN
Modem with the new settings. Generally, you will only need to
set the parameters in the Easy Setup window once.
Note: The changes you make in the Easy Setup window are not
sent to the ISDN modem until you click the Set Modem button.
When the settings on the Easy Setup and Advanced windows
exactly match the ISDN modem’s settings, the Set Modem
button is disabled.
If the parameters match those registered at the telephone company
ISDN switch, the D channel LED lights for a few minutes, flashes for
several seconds, and then turns off. If the LED continues to flash or
remains lit, see
Chapter 7 , “Troubleshooting.”
If the D channel LED indicates a proper connection to the ISDN
switch, you can place your first call. Go to the
“Placing calls with a
Macintosh computer” section on page 5-20 .