Farallon Communications 612 - Manual (Page 79)

Configuration using a Macintosh computer 5-15
Note: When you enter diagnostic mode, you cannot per form other
tasks, such as quitting the program or activating other windows,
until you exit from diagnostic mode.
To use the diagnostic mode:
1. Check the Set Diagnostic Mode box in the Utilities window.
2. Type a phone number in the Dial No. field. (Make sure you type
the number associated with an ISDN line.)
3. Click the Dial button. The diagnostic program traces the
progress of the call from the ISDN modem to the destination
and repor ts information about the call in the Results window.
4. Click the Hang Up button to hang up the line.
5. Uncheck the Set Diagnostic Mode box to exit from the diagnos-
tic mode.
Restoring the factory settings
If you experience problems, you might want to restore the Netopia
ISDN Modem’s factor y default settings. When you do this, most of
the Netopia ISDN Modem’s settings (including most of the settings
defined in the Advanced window) are returned to their original
factor y defaults. The settings defined in the Easy Setup window (the
switch type and the B channel SPIDs and director y numbers) are not
reset to their factor y defaults. In addition, the settings in S register
60 (B Channels Data Rate), 80 (Enable Multilink PPP), 82 (Multilink
PPP Endpoint ID Class), and 84 (CHAP control) are also not reset.
These settings are retained until you change them. For a summar y
of factor y default settings, see
Appendix A, “Modem Operation.”
If you configured the ISDN modem with different settings, when you
click the Restore Factor y Settings button, the ISDN Setup program
displays a dialog box that allows you to choose to save your current
modem settings. For information on saving settings,
see the
“Saving modem settings” section on page 5-18.
Updating the ISDN modem’s Firmware
For information about updating the ISDN modem’s firmware, see the
“Downloading firmware to your ISDN modem” section on page 7-8.