Windows 3.x and dos – Farallon Communications NetopiaTM User Manual
Page 16
16
Chapter 2
W
INDOWS
3.
X
AND
DOS
1.
Make sure that a Card Ser vices software is installed on your com-
puter. This section uses CardSoft as an example, so the com-
mands you enter may differ from those used here. Refer to your
vendor’s documentation for the correct commands, if needed.
2.
Enter the following command at the prompt:
C:\CARDINFO
If the Netopia ISDN PC Card is detected, the following message is
returned:
Slot 0:
Card Type = Modem (COM2)
Manufacturer = Farallon Communications, Inc.
Product Name = Netopia ISDN PC Card
Slot 1:
Slot 1 is empty
3.
Enter the following command at the prompt:
C:\TELIX
4.
Press Alt+P to open the Por t Configuration screen. Configure the
COM por t that was returned when the Netopia ISDN PC Card was
detected. Set the Speed to 115200, then press Enter to save
your changes and exit the screen.
5.
Go to Chapter 4, “VT100 Configuration Tool,” and continue from
there.