Farallon Communications NetopiaTM - Manual (Page 60)

60 Appendix B
AT!E5=n V.120 N200 (Maximum Retr y Count)
AT!E6=n V.120 T203 (Link Integrity Timer)
AT!E7=n V.120 Idle Timer
AT!N1=n * ISDN Primar y Director y Number
AT!N11=n * ISDN Alternate Director y Number
AT!N2=n Primar y Director y Number #2 (for Multilink PPP)
AT!N21=n Secondar y Director y Number #2 (for Multilink PPP)
AT!N3=n * ISDN Primar y Subaddress
AT!N31=n * ISDN Alternate Subaddress
AT!N4=n Primar y Subaddress #2 (for Multilink PPP)
AT!N41=n Secondar y Subaddress #2 (for Multilink PPP)
AT%A2=n * Rate Adaption Control
AT%A95=c Incoming Data Call Answer
AT%M1=n Local Endpoint Identifier Class
AT%M2=n Remote Endpoint Identifier Class
AT%M3=n Local Endpoint Identifier Value
AT%M4=n Remote Endpoint Identifier Value
AT%MT1=v PPP Turbo Mode Command. A setting of 0 disables turbo mode, while a setting of
128000-512000 sets the turbo bitrate value. The default setting is 512000.
AT%MT2=v PPP Turbo Mode Command. A setting between 57600 and 115200 that specifies the
minimum PC bitrate threshold for the activation of turbo mode. The default is 57600.
AT&Cn Data Carrier Detect
AT&Dn Data Terminal Ready
AT&F Load Limited Factor y Profile; Replaces all settings in current profile with default factor y
values except for ISDN Switch Type, SPID numbers, local ISDN Numbers, Subaddresses,
Rate Adaption Protocols, Outgoing ISDN Numbers, Multilink PPP Parameters
AT&Kn Flow Control
AT&Sn Data Set Ready
AT&V View Current and Stored Profile
AT&Wn Save Current to Stored Profile
AT&Yn Designate Stored Profile n as the Powerup Profile
AT&Zn=v Store Telephone Number(s)
AT@MENU Activate VT100 Configuration Tool
AT>F Restores All Profiles to Factor y Settings
AT>FC Replaces all Settings in the Current Profile with Default Factor y Values
AT>H Display a List of All Commands with Descriptions
AT Command Description