Fluke HPMS - Manual (Page 62)

RPM4/HPMS A70M/A20M-AF OPERATION AND MAINTENANCE MANUAL
© 2007 DH Instruments, a Fluke Company Page 52
1. Full scale of the AutoTest with pressure unit of
measure and measurement mode.
2. Number of test points executed/total number
of points in the AutoTest.
3. Date and time that the last point in the
AutoTest was executed.
6000 psig 6/6
20050922 10:51:01 am
Press [+/-] or [
→] to scroll through the headers of the other AutoTest data files
available. RPM4 stores up to ten AutoTest data files in order of execution with a
new data file pushing all the files back and deleting the oldest one. When the
header of the AutoTest data file you would like to view appears, press [ENT] to
view the first point of the identified AutoTest data file.
The display is:
1. RPM4 reading logged for the test point.
2. Head, AutoZ and Q-RPT indicator (same as in
the RPM4 main run screen) (see Section
3.1.1).
3. Indication that this is an AutoTest data file
view screen.
4. <FA> indicating that the AutoTest was a File
AutoTest or <QA> indicating a Quick
AutoTest. This is preceded by <OT> if the
test point was out of tolerance (definition of
out of tolerance is Set point – RPM4 reading >
DUT tolerance).
5. Number of this test point over total number of
points in the AutoTest.
0.00 psig hzHi
View data FA 1/10
Press [ENT] to move to the next data point. Press [
←] or [→] to scroll backward
and forward through the test points. The data file header is between the first
point and the last point.
Press [ESC] to exit the data file. Confirmation is required to exit the data view
function.
Up to ten data files are buffered, ten at a time, in RPM4 memory. When a new
AutoTest run is completed, its data file goes to front of the queue and the oldest
data file is deleted.
3.4.5.2 FILE
 PURPOSE
To view and edit File AutoTest definition files.
 PRINCIPLE
RPM4 supports AutoTests (see Section 3.3.10,  PRINCIPLE). There are two
types of AutoTests:
• Quick AutoTests in which the DUT and test parameters are entered “on the
fly” during the initialization of the test.
• File AutoTests in which the DUT and test parameters are stored in a file and
retrieved when the file is selected to run an AutoTest.
File AutoTest parameters are stored in definition files. [SETUP], <5AutoTest>,
<2file> allows File AutoTest definition files to be viewed and edited. Up to 40
File AutoTest definition files with up to 21 test points in each file can be created.