Stovax Aspen - Manual (Page 19)

19
5.6.4 Place the remaining 4 large coals or pebbles on top of the
square blocks, ensure that they lean against the central
small coal or pebble and that there are gaps between each
coal or pebble. See diagram 17.
It may be necessary to make small changes to the log
positioning in order to achieve the most pleasing flame
effect but the following guidelines should be followed.
5.7.1 Refer to the log identification chart and identify the
numbers corresponding to the logs that have been supplied.
See diagram 18
5.7.2 Place the two logs (No.13) on top of the beads as shown.
See diagram 19.
INSTALLATION INSTRUCTIONS
INSTALLATION
5.7.3 Place the large log (No. 1) so that it sits on top of the
previous two logs. Place the burnt effect log (No. B1) in the
centre of the tray as shown. See diagram 20.
5.7.4 Place log (No. 7) along the LH side of the tray, log (No. 9)
along the RH side of the tray and place logs (No. 8 and 11)
along the front of the tray as shown. Place the cone (No.
14) on the LH side of the burnt log. See diagram 21.
5.7.5 Place the large log (No. 6) so that it rests on top of the rear
and front logs to the LH side, Place log (No. 7) on the RH
side and log (No. 8) so that it bridges the centre gap as
shown. See diagram 22.
20
AR1275
21
AR1276
22
AR1277
18
19
AR1274
AR1273
17
5.7 Log & Driftwood Layout – Small Aspen & Chamonix
8