Stovax Aspen - Manual (Page 21)

21
INSTALLATION INSTRUCTIONS
INSTALLATION
It may be necessary to make small changes to the log
positioning in order to achieve the most pleasing flame
effect but the following guidelines should be followed.
5.9.1 Refer to the log identification chart and identify the
numbers corresponding to the logs that have been supplied.
See diagram 28.
5.9.2 Place a cone (No. 14) in the centre at the rear edge of the
tray and place one log (No. 13) at each side of the cone.
Place one log (No. 11) along the front of the tray at each
side of the pilot. See diagram 29.
5.9.3 Place the burnt effect log (No. B1) in the centre of the tray.
See diagram 30.
5.9.4 Place one log (No. 8) in the centre so that it rests on the
rear cone and the pilot shield. See diagram 31.
5.9.5 Place one log (No. 11) so that it rests on the LH front log
and the burnt log. Place another log (No. 7) so that it rests
on the RH front log and the burnt log. See diagram 32.
5.9.6 Place the two thin logs (No. 12), one at each side sitting on
the tray and resting against the previously positioned logs.
Place one log (No. 9) at the LH rear resting on the base log,
and one log (No. 8) at the RH rear. See diagram 32.
28
29
AR1282
30
AR1283
31
AR1284
32
AR1285
33
AR1286
5.9 Log & Driftwood Layout – Tahoe
8