Stovax Aspen - Manual (Page 26)

26
2.3 To release the right hand side of the control cover insert a
narrow blade screwdriver into the slot shown in diagram 3,
lever it gently and pull from the right hand side at the same
time. The cover will now come off, there is a small
cylindrical spacer inside the cover, this must be kept and
replaced on the fixing screw during re-assembly.
2.4 Disconnect the ignition lead from the gas valve and gently
pull the other end off the pilot electrode. See diagram 4.
1.1 Turn the gas supply off at the isolation device, remove the
decorative ashpan cover and disconnect the gas supply pipe
from the inlet.
1.2 Carefully remove all the loose ceramic fuelbed pieces and
place on a dry clean surface.
1.3 Remove the outer decorative basket and place to one side.
1.4 Undo the two screws securing the fire to the hearth. See
diagram 1.
1.5 Lift the fire away from the hearth and carefully tip the
firebeads (or glass granules if applicable) into a dry clean
container for later replacement.
2.1 It should be possible to replace the ignition lead without
removing the fire, if this proves difficult the the fire should
be removed, see section 1.
2.2 Undo the screw thar secures the left-hand side of the
control cover. See diagram 2.
1. FIRE REMOVAL
2. IGNITION LEAD
SERVICING INSTRUCTIONS
REPLACING PARTS
1
2
3
4