Stovax Aspen - Manual (Page 6)

6
7.3.3 Using the small beads, fill the fire to the top.
See diagram 3.
7.3.4 Smooth out the fire beads, it is important to ensure that the
fire is completely filled, level to the top.
NOTE: if your fire needs more beads, then there should be
some left over from the original installation, if not then
more must be ordered from your Gazco stockist. Do not
use any other type of material as this may seriously damage
your fire and could be dangerous.
7.3.5 Firmly pat the beads down to ensure that there are no
voids left below the surface.
7.3.6 Ensure that no beads have fallen into the pilot area.
7.3.7 Ensure that the pilot shield is fitted correctly and that it fits
tightly onto the edge of the tray. See diagram 4.
7.4.1 Place 8 large square blocks in a solid mass in the centre of
the burner tray as shown, ensure they fit tightly together.
See diagram 5.
USER INSTRUCTIONS
7.4.2 Place 14 small coals or pebbles around the edge of the tray
as shown, ensure that there are gaps between each coal or
pebble. Place one on top of the pilot shield. See diagram 6.
7.4.3 Starting at the front, place 14 alternating large and small
coals or pebbles around the perimeter of the fire, they
should sit on the bottom row of small coals or pebbles and
rest against the inner mass of square blocks. See diagram 7.
7.4.4 Place the remaining 6 large coals or pebbles on top of the
square blocks, ensure that there are gaps between each coal
or pebble. See diagram 8.
3
4
5
6
7
AR1263
AR0558
AR1262
AR1264
7.4 Coal & Pebble Layout - Small Aspen & Chamonix
AR1265
8