Microtek Converter - Manual (Page 10)

6
2. Make sure that the SCSI ID of the SCSI device is set properly. It must be
from 0 to 6. ID 7 is reserved for the FR1SX. SCSI ID is usually set with a
switch on the back of the SCSI device. For more information how to set SCSI
ID, refer to the SCSI device’s manual.
3. Attach an active terminator to the SCSI device, as Fig.3 shows. If the SCSI
device has an internal terminator instead of external terminator, it must be
enabled.
4. Turn ON the SCSI device and check if the green LED on the FR1SX is lit.
If the green LED is not lit, the SCSI device doesn’t have Term-Power output
capability. If the SCSI device doesn’t have this capability, an optional AC
Adapter is needed. Regarding optional items, refer to Chapter 8.