Microtek Converter - Manual (Page 13)

9
3. How to check if device is working
Try following sequence, too.
1. Unplug the firewire cable from the FR1SX or the computer.
2. Turn off the SCSI device.
3. If an optional AC adapter is used, unplug the AC adapter from the FR1SX.
4. Turn on the SCSI device and plug the AC adapter at the same time as possible
as you can. If it is difficult, turn on the SCSI device first.
5. After self initialization of the SCSI device, plug the firewire cable to the
FR1SX or the computer.
6. Wait about 5 seconds for recognition by the system and see if the SCSI device
is recognized.
If the SCSI device is not recognized:
Double check followings.
1. Is green LED on the FR1SX lit? If not, refer to Chapter 8.
2. Is terminator attached to the SCSI device properly?
3. Is SCSI ID of the SCSI device set properly? ( Must be 0 - 6 )