Microtek Converter - Manual (Page 28)

24
Delay time until 1394 transaction start (sec.)
Default value is 4. If START UNIT command is disabled(Default), it
indicates the delay time to start 1394(firewire) transaction. If START UNIT
command is enabled, it indicates the delay time for the next command after
being issued Start/Stop Unit command. Some SCSI devices cannot take any
SCSI command right after Start/Stop Unit command is issued.
Enable SCSI bus reset
Default is enabled. If it is enabled, SCSI bus reset is issued. If disabled, SCSI
bus reset is not issued.
Enable START UNIT command (Start/Stop UNIT command)
Default is disabled. Some SCSI devices don’t spin up if Start/Stop unit
command is not issued.
Enable parity check
Default is enabled. If the SCSI device doesn’t have parity check function, it
should be disabled.
Target SCSI ID.
Default value is AUTO. You can specify the target SCSI ID.
Max Payload Size (IEEE1394)
Default value is 1024. You can set Max byte size in transferring IEEE1394
data block. Max size is 2048 Bytes. You should set this value to 1024 for
Blue&White PowerMac G3.