Microtek Converter - Manual (Page 6)

2
1-2. Layout
AC Adapter jack
Power LED (Green)
Fig. 1 shows the front side layout of the FR1SX. Power LED light-on
state indicates the FR1SX is powered. If this LED is NOT lit, an optional AC
adapter is needed. Refer to Chapter 8 regarding optional items.
High-Density 50 pin
SCSI connector
Fig. 2 shows the back side layout of the FR1SX. The FR1SX has a High-
Density 50 pin SCSI male connector. If you have a SCSI device with a different
type such as High-Density 68 pin, Centronics 50 pin or D-Sub 25 pin, you can
use an optional adapter. In such a case, refer to Chapter 8.
Fig. 1 Front Side
Fig. 2 Back Side
6 pin FireWire
(IEEE1394) port