Configuration utility, 1. you can change following settings – Microtek Converter User Manual
Page 27
Macintosh
23
4. Configuration Utility
You can change configuration settings on the FR1SX for the SCSI device
with using the utility. You can update/change firmware with the same utility,
but refer to Chapter 5 regarding Firmware Update.
4-1. You can change following settings.
SIM Driver mode
Default is enabled. It is only for MacOS 9.
Transfer Mode/Speed (SCSI)
Default value is 20MB/s. You can select 20, 10, 5MB/s and Async.
Delay time between power on and SCSI bus reset (sec.)
You can set the delay time for some SCSI devices which hang up if SCSI bus
reset is issued right after the FR1SX gets powered.
Delay time between SCSI bus reset and SCSI command (sec.)
You can set the delay time for some SCSI devices which hang up if SCSI
command is issued right after SCSI bus reset.