Multi-Tech Systems MULTIVOIP MVP210/410/810 - Manual (Page 42)

Chapter 4: Configuring your VOIP
Multi-Tech Systems, Inc. 42
FXS Loop Start Interface: Parameter Definitions (continued)
Field Name Values Description
Flash Hook Options fields
Generation -- Not applicable to FXS interface
Detection Range for Min. and
Max., 50 - 1500
milliseconds For a received flash hook to be regarded as such by the MultiVOIP, its
duration must fall between the minimum and maximum values given
here
Pass Through
Enable Y/N When enabled, this parameter creates an open audio path through the
MultiVOIP.
If the Pass-Through feature is enabled, the AutoCall feature must be
enabled for this VOIP channel in the Voice/Fax Parameters screen
Caller ID fields
Type Bellcore The MultiVOIP currently supports only one implementation of Caller
ID. That implementation is Bellcore type 1 with Caller ID placed
between the first and second rings of the call.
Enable Y/N Caller ID information is a description of the remote calling party
received by the called party. The description has three parts: name of
caller, phone number of caller, and time of call. The ‘time-of-call’
portion is always generated by the receiving MultiVOIP unit (on FXS
channel) based on its date and time setup.
The forms of the ‘Caller Name’ and ‘Caller Phone Number’ differ
depending on the IP transmission protocol used (H.323, SIP, or SPP)
and upon entries in the phonebook screens of the remote (CID
generating) VOIP unit. The CID Name and Number appearing on the
phone at the terminating FXS end will come either from a central office
switch (showing a PSTN phone number), or the phonebook of the
remote (CID sending) VOIP unit.
CID Manipulation Enabled by
default with
Caller ID enable
above
Disable This is not implemented in the –SS series VOIPs.
Caller ID Manipulation is used whenever the user wants to manipulate
the Caller ID before sending it to the remote end. Caller ID
Manipulation is activated on the Interface Screen. By enabling Caller
ID option, you can set manipulation to Transparent, User CID, Prefix,
Suffix, or Prefix and Suffix. Caller ID Manipulation is a feature, where
the Caller ID detected from the PSTN line can be changed and then
sent to the remote side over IP.
CID Mode Transparent,
User CID,
Prefix,
Suffix The MultiVOIP is not allowed to modify the caller ID info and then
send it to the PSTN side. It only allows it to detect the caller ID
from the PSTN line, modify it and then send them via IP to the
remote end point.
Transparent: the CID received from PSTN will be sent out as such,
without any manipulation.
User CID: the CID received from PSTN will be replaced by this User
CID value.
Prefix: the CID received from PSTN will be prefixed with this value.
Suffix: the CID received from PSTN will be suffixed with this value.