Multi-Tech Systems MULTIVOIP MVP210/410/810 - Manual (Page 79)

Chapter 5: Phonebook Configuration
Multi-Tech Systems, Inc. 79
5. In the “Destination Pattern” field of the Add/Edit Outbound Phonebook screen, enter the digits from step
4 followed by the digits from step 3.
North America,
Long-Distance Example Euro, National Call Example Euro, International Call
Example
Seattle/Chicago system.
Answer : enter 81312 as
Destination Pat-tern in
Outbound Phone-book of
Seattle VOIP.
London/Birmingham system.
Leading zero of Birmingham area
code is dropped when combined
with national-dialing access
code. (Such practices vary by
country.)
Answer : enter 90121 as
Destination Pattern in Outbound
Phonebook of London VOIP.
Not 900121.
Rotterdam/Bordeaux system.
Answer : enter 903305 as
Destination Pattern in
Outbound Phonebook of
Rotterdam VOIP.
6. In the “Remove Prefix” field, enter the initial PBX access digit (“8” or “9”).
North America,
Long-Distance Example
Euro, National Call Example Euro, International Call
Example
Seattle/Chicago system.
Answer : enter 8 in “Remove Prefix”
field of Seattle Outbound
Phonebook.
London/Birmingham system.
Answer : enter 9 in “Remove Prefix”
field of London Outbound
Phonebook.
Rotterdam/Bordeaux system.
Answer : enter 9 in “Remove Prefix”
field of Outbound Phonebook for
Rotterdam VOIP.
Note: Some PBXs will not ‘hand off’ the “8” or “9” to the VOIP. But for those PBX units that do, it’s important to enter
the “8” or “9” in the “Remove Prefix” field in the Outbound Phonebook. This precludes the problem of having to make
two inbound phonebook entries at remote VOIPs, one to account for situations where “8” is used as the PBX access
digit and another for when “9” is used.
7. In the “Protocol Type” field group, select the VOIP protocol that you will use (H.323, SIP, or SPP). Use the
appropriate screen under Configuration | Call Signaling to configure the VOIP protocol in detail.
8. Click OK to exit from the Add/Edit Outbound Phonebook screen.