Multi-Tech Systems MULTIVOIP MVP210/410/810 - Manual (Page 9)

Multi-Tech Systems, Inc. 9
Chapter 2 – Installing and Cabling the
MultiVOIP
Introduction
The MVP210 MultiVOIP models are tabletop units that can be handled easily by one person. However, the
MVP410 and MVP810 MultiVOIPs are somewhat heavier units. When these units are to be installed into a rack,
two able-bodied persons should participate. Please read the safety notices before beginning installation.
Safety Warnings
Lithium Battery Caution
A lithium battery on the voice/fax channel board provides backup power for the timekeeping capability. The
battery has an estimated life expectancy of ten years. When the battery starts to weaken, the date and time may
be incorrect. If the battery fails, the board must be sent back to Multi-Tech Systems for replacement.
Warning: There is danger of explosion if the battery is incorrectly replaced.
Safety Warnings Telecom
1. Never install telephone wiring during a lightning storm.
2. Never install a telephone jack in wet locations unless the jack is specifically designed for wet locations.
3. This product is to be used with UL and UL listed computers.
4. Never touch un-insulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
electrical shock from lightning.
7. Do not use a telephone in the vicinity of a gas leak.
8. To reduce the risk of fire, use only a UL-listed 26 AWG or larger telecommunication line cord.
Unpacking Your MultiVOIP
When unpacking your MultiVOIP, check to see that all of the items are included in the box. For the various
MultiVOIP models, the contents of the box will be different. If any box contents are missing, contact Multi-Tech
Tech Support at 1-800-972-2439.
MVP210 models content list:
• MVP210
• DB9 to RJ45 cable
• Power transformer
• Power cord
• Printed Cabling Guide
• Product CD
MVP410/810 models content list:
• MVP410 or MVP810
• DB9 to DB25 cable
• Mounting brackets and screws
• Power cord
• Printed Cabling Guide
• Product CD