Monessen Hearth Direct Vent Gas Fireplace CDVR36 - Manual (Page 5)

69D0023 5
PRODUCT FEATURES
AND
CODE APPROVAL
Off/Pilot/On Knob
Remote Control
Figure 1 - CDVR33, CDVT33, CDVR36 and CDVT36 Fireplace
• This appliance has been certified for use with either natural or propane gas. See appropriate data plates.
• This appliance is not for use with solid fuels.
• The appliance is approved for bedroom or bedsitting room installations.
• The appliance must be installed in accordance with local codes if any. If none exist use the current installation code.
ANSI Z223.1/NFPA 54 in the USA, CAN/CGA B149 in Canada.
• This appliance is mobile home approved.
• The appliance must be properly connected to a venting system.
• The appliance is not approved for closet installations.
• This appliance is approved to be vented with Simpson-Duravent and Selkirk-Metalbestos Direct Vent Components.
NOTE: For illustration purposes only, all drawings show the Simpson-Duravent System.
Hi/Lo Knob
PRODUCT SPECIFICATIONS
The efficiency rating of this appliance is a product thermal efficiency rating determined under continuous operating condi-
tions and was determined independently of any installed system.
Thermal Efficiency = up to 80%
CODE APPROVAL
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS
FIREPLACE HEATERS in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE HEATER
TESTED TO: ANSI Z21.88/CSA 2.33 STANDARDS
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured Home Con-
struction and Safety Standard, Title 24 CFR, Part 3280, or when such a standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1, or Standard for Gas Equipped Recreational Vehicles and
Mobile Housing, CSA Z240.4.
Blower Control
On/Off/RS Switch
Ignitor