Mercedes-Benz 2006 CL 500 - Manual (Page 176)

175
Controls in detail
Automatic transmission
Manual shift program CL 55 AMG and
CL 65 AMG
In addition to the automatic shift
program C or S, your vehicle is equipped
with the manual shift program M.
In the manual program mode M,
system-controlled automatic gearshifting
is switched off and you need to change the
gears by manually upshifting or downshift-
ing using the steering wheel gearshift but-
tons to the left and right of the steering
wheel (
୴ page 173) or the gear selector
lever.
The program mode selector switch is
located on the lower part of the center
console.
1 Program mode selector switch
M Manual For manual gear shifting
C Comfort For comfort driving
S Sport For standard driving
The current gear selector lever position
and the selected program mode (
M / C / S )
are indicated in the tachometer display
(
୴ page 166).
!
Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gear R or parking
position P only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.