Marathon Computer AACC 2000 - Manual (Page 29)

Marathon Monitors Inc.
AACC 2000 Carbon Nov. 1, 1997 29
MANUAL MODE
If the AUTO light is on, press the AUTO/MAN button to select manual mode.
The MAN light comes on.
Power on
x 2
The Home display
Check that the MAN light is on.
The upper readout shows the measured
temperature, or process value. The lower
readout shows the % output.
To adjust the output, press
or . .
(Note: If Output Rate Limit has been enabled,
then the lower readout will show the working
output. If
or . is pressed, it will
change to show and allow adjustment of, the
target output.)
Press
once.
Display units
A single press of
flashes the display units
for 0.5 seconds, after which you are returned
to the Home display.
Flashing of the display units may have been
disabled in configuration, in which case a
single press will take you straight to the
display shown below.
Press
twice.
Setpoint
To adjust the setpoint value, press
or .
Press
.
Pressing from the Output Power display may access further parameters. These may
be in this scroll list if the ‘Promote’ feature has been used (see Chapter 3, Edit Level).
When you reach the end of this scroll list, pressing
will return you to the Home
display.