Moog DS2100 - Manual (Page 31)

SECTION 3: WIRING AND INSTALLATION
DS2100 User's Manual (Preliminary)
PAGE 3-25
3.6 Sequence of Component Wiring Recommendations
The following sequence for wiring is a recommendation. Individual wiring steps are denoted by a box character, which
can be used as an installation check off list.
The terminal block layout on all power supplies and servo-drives has been designed to isolate low voltage from high
voltage circuits. Cabinet conduits should be arranged to maintain this physical separation.
a) Power Circuit Wiring
q Wire a 24V Logic Supply to the drive (Required on mA size drives). Fit a suitable EMC filter on the 24V logic
Supply and fuse.
q Wire a.c. mains input to a user supplied fuses. Make a secure and reliable connection between the chassis of the
equipment and Earth.
q Fit a suitable EMC Mains Line Filter after the User supplied fuses and contactor.
q Wire a.c. mains from the user-supplied contactor to the power input poles of the DS2100.
b) Servo-drive Wiring
q Plug in Axis I/O cable to J2 and connect other end to user I/O equipment.
q Plug in resolver cable at J5 (or Encoder Cable to J4).
q Connect appropriate communications cabling (RS232 at J1, and/or Field Bus
c) Motor Wiring
q Repeat the steps listed in this Section for each motor in the system.
q Plug in and screw tight resolver/encoder cable to motor position connector.
q Plug in and screw tight motor power cable to motor power connector. Also connect the brake terminations at J2D
(if provided).
q Connect motor power cable to appropriate drive power terminals.