Moog DS2100 - Manual (Page 49)

SECTION 3: WIRING AND INSTALLATION
DS2100 User's Manual (Preliminary)
PAGE 3-43
3.11.2 Motor Power Cable
Wire the motor power connector in accordance with Figure 3.29 to Figure 3.35.
Use wire sizes based on the motor’s continuous stall current (r m s) and wire length requirements.
For proper drive commutation of motors, it is required that the motor phase conductors, Phase U, Phase V , and Phase
W be wired exactly.
Wiring must be in accordance with standard EN 60204-1 (See Section
2 of this Users Manual.)
Required for
CE-Compliance