Ups control, Network management cards, User manual – MGE UPS Systems 66074 User Manual
Page 16
www.mgeups.com
Network
Management Cards
User Manual
T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
Network Management Card
– User Manual
34003676EN/GA
Page
16/69
3.2.3.2 Battery measurements
3.2.3.3 By Pass measurements
3.2.4 UPS Control
Click on the “UPS Control” section in the menu.
If the UPS is not compatible with this function, a warning message is sent to the user.
UPS configuration may also prevent the commands from being properly run. Read the UPS manual for more
information.
This page enables triggering of
startup and shutdown sequences
for the UPS main output and Controlled
outlets.
Z
The status of each output is displayed by a symbol associated with the Off label (red symbol) or Powered
(green symbol).
Z
The shutdown sequences take into account the time required for the registered servers to shut down
without losing data (
). Once the sequence has started, the commands are
disabled until it ends.
Z
After a startup sequence, the commands are disabled for 120 seconds to enable the servers to fully restart
By Pass current
By Pass voltagePhase / Phase
Remaining backup time estimted by the UPS
Battery charge level
Battery voltage
Battery current – Negative when discharging
Battery temp. – Internal temperature probe