Monessen Hearth Direct Vent Gas Fireplace MDV500 - Manual (Page 32)

32 75D2523
#1
#2
#3
#4
#5
#6
7#
Electronic Valve
GRAY #7
RED #2 RED #2
BLACK #4
GREEN #6
BLUE #1
BLUE
YELLOW
YELLOW
WHITE #3
MAGENTA #5
15’ Wall Switch Wire
BLACK
WHITE Switch
RS
OFF
ON
Transformer
Secondary
24V
WHITE
WHITE
GREEN
BLACK
BLACK
Primary - 120V
To Junction Box
Pilot Assembly
Spark
Sense
Ignition Module (Synetek)
HI
LO EV1 EV2
ELECTRICAL INSTALLATION
ELECTRONIC PILOT IGNITION WIRING
REMOTE WALL SWITCH
Position the wall switch. Do not extend beyond the 15 feet of wire.
OPTIONAL DC REMOTE SYSTEMS
These instructions replace the section entitled Hearth Mount in the Millivolt hand held remote instructions supplied with
the remote.
1. Follow instructions on remote control to snap remote cover plate to remote receiver.
2. Connect the wire terminal from the remote receiver. This replaces the 15' wall switch connection to the switch. See
Figure 41.
3. Use screws that came with remote control to mount remote control receiver at junction box (for your wall switch) or at
control panel (when installation in unit is preferred).
Figure 41 - Electronic Ignition System Wiring Diagram
WARNING
Do not connect 110-120 VAC to the
Remote Wall Switch. The appliance
will malfunction.