Mega System Tech iCV-02 - Manual (Page 12)

iCAMView user manual -9-
Chapter 4: Using iCAMView Utility to Setup IP & Update Firmware
2.1 Setup Wizard
Use “Setup Wizard” to take you through the basic configurations necessary to start
using iCAMView.
1. Click to highlight the iCAMView on the right that you want to configure.
2. Click on “Setup Wizard”.
3. iCAMView Setup Wizard will initiate to take you through the installation.
4. Enter the necessary camera configurations. Choose the appropriate frequency
(Indoor 60 Hz, Indoor 50 Hz or Outdoor) to prevent flickering on the video feed.
Enter a name for the camera in the “Location” box to easily identify it.
5. Click “Next >” to configure the Network Connection.
“Obtain an IP address by DHCP”
Choose this if you do not know your basic Network Configurations
“Use the following IP Address”