Mega System Tech iCV-02 - Manual (Page 30)

iCAMView user manual -27-
Chapter 5: iCAMView Web Manager
This option determines the iCAMView Network settings.
i. IP Address
These items were all setup earlier in Setup Wizard. Enter new addresses and
click “Apply” to change.
Fig.20. iCAMView IP Address Settings
“IP Address”
This item determines iCAMView IP Address.
“Subnet Mask”
This item sets iCAMView Subnet Mask. The value is normally 255.255.255.0
“Gateway”
This item is to set iCAMView Gateway.
“Obtain an IP address”
This allows the user to choose either to set iCAMView IP Address manually or
via DHCP. iCAMView will reboot after the above settings have been changed.
ii. DNS Server IP
Fig.21. iCAMView IP DNS Server IP
“Primary DNS Server IP”
This item sets iCAMView primary DNS Server IP address.
“Secondary DNS Server IP”
This item sets iCAMView secondary DNS Server IP address. iCAMView will use
the secondary DNS Server IP address if the Primary DNS Server IP address is
not working.
iii. Port Number
Fig.22. iCAMView Port Settings
“HTTP Port Number”
By default the port number is 80.