Mega System Tech iCV-02 - Manual (Page 23)

iCAMView user manual -20-
Chapter 5: iCAMView Web Manager
Chapter 5: iCAMView Web Manager
Section 1. Introduction
After you have setup the hardware and set an IP address for iCAMView, you will then
be able to go to iCAMView web site to monitor and control the PC cameras. All you
have to do is enter the new IP address into any web browser.
1. Start the Web Brower (Netscape or Internet Explore)
2. Enter the iCAMView IP Address that was set earlier using “Setup Wizard” (e.g.
192.168.0.30, if you do not remember, goto to iCAMView and look at the LCD
display) and press ENTER
Fig.13. Enter iCAMView IP address
3. A login screen will appear. Enter the Administrator User Name and Password if
you have set these in the “Setup Wizard”. Otherwise, just press ENTER.
Fig.14. iCAMView Login screen
Section 2. iCAMView Web Manager Interface
The iCAMView webpage main menu is divided into two sections. The selection menu
on the left and display menu on the right. The selection menu consists of the following
options:
2.1 Web-Camera Selection