Intel SX220 - Manual (Page 123)

Viglen SX220 User Guide 122
Are all DIMMs installed correctly?
Are all peripheral devices installed correctly?
If the system has a hard disk drive, is it properly formatted or configured?
Are all device drivers properly installed?
Are the configuration settings made in BIOS Setup correct?
Is the operating system properly loaded? Refer to the operating system
documentation.
Did you press the system power on/off switch on the front panel to turn the server
on (power on light should be lit)?
Is the system power cord properly connected to the system and plugged into a
NEMA 5-15R outlet for 100-120 V
∼
or a NEMA 6-15R outlet for 200-240 V
∼
?
Is AC power available at the wall outlet?
Are all integrated components from the tested components lists? Check the
tested memory, and chassis lists, as well as the supported hardware and
operating system list on the Intel Customer Support website.
Running New Application Software
Problems that occur when you run new application software are usually related to
the software. Faulty equipment is much less likely, especially if other software runs
correctly.
Checklist
Does the system meet the minimum hardware requirements for the software?
See the software documentation.
Is the software an authorised copy? If not, get one; unauthorised copies often do
not work.
If you are running the software from a diskette, is it a good copy?
If you are running the software from a CD-ROM disk, is the disk scratched or
dirty?
If you are running the software from a hard disk drive, is the software correctly
installed? Were all necessary procedures followed and files installed?
Are the correct device drivers installed?
Is the software correctly configured for the system?
Are you using the software correctly?
If the problems persist, contact the software vendor’s customer service
representative.
After the System Has Been Running Correctly
Problems that occur after the system hardware and software have been running
correctly often indicate equipment failure. Many situations that are easy to correct,
however, can also cause such problems.
Checklist
If you are running the software from a diskette, try a new copy of the software.