Intel SX220 - Manual (Page 95)

Viglen SX220 User Guide 94
Modem Init String
The Modem Init String string is transmitted every time the EMP initialises. The
length of the paging string is determined at run-time from firmware. You will be
notified if the string is truncated. The string that has been saved is the one that will
be shown in the edit box.
System Phone Number
Enter the system telephone number. This can be retrieved and reported via in-band
management connections.
Access Mode
In Pre-boot Only the EMP is automatically activated when the system is powered-
down or hard reset. In Always Active the EMP is active when the system is
powered-down or hard reset. In Disabled the EMP powers-up deactivated and is not
automatically activated by BIOS, power-down or hard resets.
Restricted Mode Access
When restricted mode is enabled control operations that could disable or alter a
running system via the EMP are disabled.
Connection Mode
Direct connect mode is for applications that connect the port directly to another
computer system, while Modem Mode is for applications where the port is connected
to an external modem.
Buttons
•
Save: Allows you to save the configuration immediately.
•
Close: Allows you to close the Emergency Management Port dialog without
saving changes. If you have made changes, you will be prompted to save
changes before closing.
•
Help: Displays help information.
Exiting the SSU
Exiting the SSU causes all windows to close.
1. Exit the SSU by opening the menu bar item File in the SSU Main window.
2. Click on Exit or Highlight Exit, and press <Enter>.