Intel SX220 - Manual (Page 41)

Viglen SX220 User Guide 40
Install the Processor Terminator
If you are installing only one processor, you must install a terminator in the
secondary processor socket (A). If you are installing two processors, skip this
section.
1. Raise the locking bar (B) on the socket.
2. Aligning the two corner marks on the terminator with the handle-side of the
socket (C), insert the terminator into the socket.
Lower the locking bar completely (D).
Figure 21: Installing the Processor Terminator
Memory
Only PC-133 compliant SDRAM is supported by the SX220 server board. Install from
128 MB to 6 GB of registered, ECC memory, using up to six DIMMs.
DIMMs must be installed in pairs and in the following order: 1a and 1b, 2a and 2b, 3a
and 3b.
Installed DIMMs must be the same speed and must all be registered. For a list of
supported memory, call your service representative.