Intel SX220 - Manual (Page 37)

Viglen SX220 User Guide 36
Adding Components to the Server Board
After installing the server board, you must add the desired number of processors and
memory DIMMs.
NOTE: Once the server board and its components are installed, you are done
assembling the system unless you have optional peripherals or add-in
cards you wish to install. If you need to install these components, continue
on to the next section. Otherwise, install the cover and bezel and continue
on to Chapter 5, “Installing the System in a Rack” found on page 51.
Installing Processors
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Raise the locking bar on the socket.
3. Observe the safety and ESD precautions at the beginning of this chapter.
4. Raise the locking bar on the socket.
Figure 16 Raising the Locking bar on the socket
5. Aligning the pins of the processor with the socket, insert the processor into the
socket.
6. Lower the locking bar completely.