Intel SX220 - Manual (Page 90)

Viglen SX220 User Guide 89
Help Topics Menu
The Help Topics menu has the following options:
•
Help Topics: Displays help information.
Enable LAN Alerts Checkbox
Enables or disables BMC LAN-Alerting.
Enter New Password
Allows you to enter a LAN password. The valid range of characters includes ASCII
values 32-126. The password must be from 1-16 characters long.
Verify New Password
Enter the same password as above.
LAN Access Mode
Allows you to set the remote access mode desired. In Enabled mode, a remote
system can initiate a LAN session regardless of system state or health. In Disabled
mode, remote LAN sessions cannot be initiated. In Restricted mode, control
operations cannot be performed such as power down, front panel NMI, and reset.
SNMP Community String
Can be configured for the community field in the Header section of the SNMP trap
sent for a LAN alert. The default string is ‘public’. The string must be from 5-16
characters long.
IP Configuration
•
DHCP: Enables the dynamic host configuration protocol to allow the server
to automatically assign the host IP address, router IP address and subnet
mask. The host IP address, router IP address and subnet mask will not be
saved if this radio button is checked.
•
Static: Allows you to set the server host IP address, router IP address and
subnet mask. The host IP address, router IP address and subnet mask will
be saved if this radio button is checked. The values saved will take effect
immediately.
Host IP Address
Enter the Logical or Internet Address of the host. The Host IP Address will only be
saved when DHCP is disabled. The IP is entered as a dotted IP, (e.g., 192.168.0.2).