Intel SX220 - Manual (Page 43)

Viglen SX220 User Guide 42
3. Firmly push the PCI card connector into the riser card slot until it is fully seated.
4. Close the retainer clip (A). Ensure the clip is latched.
Figure 23: Installing a PCI card of the riser
Installing a Riser Card on the Server Board
1. Insert the riser card connector into the server board slot while aligning the tabs on
the rear retention bracket with the holes in the chassis.
CAUTION!
Press the riser card straight down into the slot. Tipping it into the slot while installing
it may damage the riser card or slot.
2. Firmly press the riser card straight down until it is fully seated in the server board
slot.