Intermec 751G User Manual
Page 139
Chapter 5 — Network Support
751G Color Mobile Computer User’s Manual
125
Using Static WEP Security
The 751G uses the Wired Equivalent Privacy (WEP) protocol to add
security to your wireless network based on the 802.11b/g standard. To use
WEP security, you need an access point with an 802.11b/g radio.
Configuring Static WEP Security With Funk Security
Use this procedure to set Static WEP security with Funk security.
1
Make sure you have configured the communications and radio
parameters on your 751G and that Funk is your security choice.
2
Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with “X” being “1” through “4.”.
3
For Association, select “Open” and press Enter.
4
For Encryption, select “WEP” and press Enter.
5
For 8021x, select “None” and press Enter.
7
For Transmit key, select which WEP key to use for encryption of
transmitted data.
8
Define a value for each key, up to four. Enter an ASCII key or a hex key
either 5 or 13 bytes long based on the radio capability. Set a 5-byte value
for 64-bit WEP or a 13-byte value for 128-bit WEP. Precede hex keys
with 0x and make sure the keys use 5 or 13 hex pairs.