Intermec 751G - Manual (Page 20)

Chapter 1 — Using the Computer
6 751G Color Mobile Computer User’s Manual
5 Charge the battery pack for three hours before using. However, to ensure
proper charging, perform the remaining steps first, with the AC adapter
or dock connected:
a The first time you turn on your 751G, it boots to the operating
system. After a few seconds, you see the Windows CE .NET Desktop
screen. Tap your stylus to advance to the next display on the screen.
b You will be prompted through the several screens to complete the
setup process. Read the display messages and follow the instructions.
When you reach the Windows CE .NET Desktop screen, you have
completed the setup.
Removing the Battery
Follow these instructions to remove the battery from the 751G.
To remove the battery
Pull up on the battery compartment latch, then lift the battery out of the
battery compartment.
You must use only the Intermec power supply approved for use with
the 751G. Using any other power supply will damage the 751G.
Note: For help installing and using the single dock, see the 700 Series Single
Dock Quick Start Guide (P/N 962-040-009) shipped with the dock.
Only use the battery compartment latch to dislodge and remove the
battery. Using any other tool or method to remove the battery may
damage the battery or the 751G.
Removing the main battery when the backup battery low or critically
low icon appears on the status bar may cause your 751G to cold boot
and you may lose data.
If you fail to replace the battery immediately, you may lose important
data or applications.
Battery compartment latch
Battery compartment
Battery pack