Intermec 751G - Manual (Page 31)

Chapter 1 — Using the Computer
751G Color Mobile Computer User’s Manual 17
2 Align the folded edge of the pull tab where there is no adhesive with the
bottom end of the storage card. Peel away the rest of the paper from the
long end, then firmly press down the remaining adhesive area of the tab
onto the storage card.
3 Insert the storage card, with the contacts facing the keypad, into your
751G to ensure that no adhesive is exposed once the tab is placed.
4 Press on the storage card until you hear a click. If needed, close the
storage media access door.
Accessing Files Stored on the Secure Digital Card
When inserted in the 751G, the Secure Digital card inserted in your 751G,
it appears as the “\SDMMC Disk” folder. To access this folder, select My
Computer, then tap the “\SDMMC Disk” folder.
Removing the Secure Digital Card
1 Press the Power key for seconds, and then release the Power key to turn
off the 751G. Remove the storage media access door.
2 Gently depress the Secure Digital card to release the card, then pull the
card from its slot.
3 Replace the storage media access door.
4 Press the Power key for two to three seconds, and then release the Power
key to turn on the 751G.
Wireless Network Support
Radios are installed at the factory and cannot be installed by a user. The
751G must be serviced to install or replace radios. Contact your Intermec
representative for more information. See
Chapter 5, “Network Support”
for information about supported radios.
Note: Changes or modifications not expressly approved by Intermec could
void the user’s authority to operate the equipment.
Align the folded end with this edge of the storage card
Keypad facing down